|
|
|
TURNIGY marine ESCs are built with USA IR mosFETs for long run times and less heat.
Boat escs have a different requirement to air or car escs.
Their need for sustained high-amp draw makes plane escs unsuitable and car escs
with large amp spike capability, unnecessary.
Thats why TURNIGY marine escs are designed purely for boats, and coated in anti-static then water resistant laquer to prevent shorting should the esc get wet.
They can handle sustained high amp/volt loads and handle
|
|
|
|
|
MultiStar ESCs are are a quality speed controller at a fantastic price! Designed for simple installation and easy setup these ESCs have proven to offer excellent performance when used in Multi-rotor applications. If your starting out in Multi-rotors and need an easy to install solution that is tested and proven to work with Multi-rotor craft then these speed controllers have you covered.
These ES
|
|
|
|
|
The Turnigy series are programmable car and boat brushless speed controllers. The Turnigy series boasts features such as large burst currents, programmable breaking and reverse, low resistance, 2-3 Lipo cell capable and low weight.
Specification:
Cont. Current: 18A
Burst Current: 50A
Resistance: 0.001ohm
Car Size: 1/16
Suggested Motor: Around 12T / 2030kv
Battery: 2 Cell Lipo / 4-6 Cell Ni-XX
BEC: 6V/ 1.0A Output
Motor Type: Sensorless Brushless
Size: 31.5*24*15mm
Weight: 19g
A
|
|
|
|
|
Turnigy® dlux SBEC ESCs have set a new bench mark in quality and performance, so much so that this lightweight and highly versatile ESC can handle up to 6s and + 10A burst current with complete peace of mind. The extensive programming and data Logging features also offer a versatility of applications rarely seen in an ESC of this rating. All Turnigy dlux ESCs can be programmed via a programing ca
|
|
|
|
|
MultiStar ESCs are are a quality speed controller at a fantastic price! Designed for simple installation and easy setup these ESCs have proven to offer excellent performance when used in Multi-rotor applications. If your starting out in Multi-rotors and need an easy to install solution that is tested and proven to work with Multi-rotor craft then these speed controllers have you covered.
These ES
|
|
|
|
|
Our most powerful ESC now with a more compact design, wider voltage range and lower price! The Turnigy Fatboy V2 speed controller is rated at a massive 300 Amp continuous currentdraw and 380 Amp burst!
The Fatboy V2 features a large aluminum heat sink case, dual 8AWG input wires, 8AWG outputwires for the motor and anti-spark protection.
The optional programming box (sold separately, see related items below) makes setup of theTurnigy Fatboy fast and easy. This ESC is suited t
|
|
|
|
|
TURNIGY marine ESCs are built with USA IR mosFETs for long run times and less heat.
Boat escs have a different requirement to air or car escs.
Their need for sustained high-amp draw makes plane escs unsuitable and car escs
with large amp spike capability, unnecessary.
Thats why TURNIGY marine escs are designed purely for boats, and coated in anti-static then water resistant laquer to prevent shorting should the esc get wet.
They can handle sustained high amp/volt loads and handle
|
|
|
|
|
|
The Turnigy K-Force series are based on an all new powerful microprocessor usually reserved for high speed car ESCs. The new CPU means ultra fast sync timing, crisper throttle response, less battery load and reduced FET heat buildup.
Specification:
Output: Continuous 40A, burst 57A up to 10 seconds.
Input Voltage: 2-6 cells lithium battery or 5-18 cells NIMH battery.
BEC: Twin voltage selection, 5.25v and 6v.
Control Signal Transmission: Optically coupled system.
Max Speed;
2
|
|
|
|
|
MultiStar ESCs are are a quality speed controller at a fantastic price! Designed for simple installation and easy setup these ESCs have proven to offer excellent performance when used in Multi-rotor applications. If your starting out in Multi-rotors and need an easy to install solution that is tested and proven to work with Multi-rotor craft then these speed controllers have you covered.
These ES
|
|
|
|
|
Ultra fast microprocessor controlled, extremely low resistance circuit and chip design, and aluminum heatsink for better thermal dissipation are just some of the features in the new TURNIGY Super Brain range of brushless speed controllers.
The Super Brain brushless esc is a high performance ESC capable of standard and competition use.
Full protection, including signal loss, over-temperature.
Programable by USB, PC or your Tx.
Compatible with all radio systems.
Features:
Supports
|
|
|
|
|
The Turnigy AE series are based on new powerful microprocessor.
The new CPU means ultra fast sync timing, crisper throttle response, less battery load and reduced FET heat buildup. Also there is a separate voltage regulator IC for microprocessor providing good anti-jamming capability.
Specification:
Output: Continuous 100A, burst 115A up to 10 seconds.
Input Voltage: 2-6 cells lithium battery or 5-18 cells NIMH battery.
BEC: Linear 4A @ 5V
Control Signal Transmission: Optically
|
|
|
|
|
Turnigy® dlux ESCs have set a new bench mark in quality and performance.Each ESC uses a twin PCB design separating the motor power supply & MCU.This design allows for optimum component layout on each PCB and provides the ideal configuration for heat dissipation and thermal efficiency.Both PCBs are enclosed in a full aluminum heat sink casing to ensure maximum heat dispersion.All Turnigy dlux ESCs
|
|
|
|
|
The Turnigy TrackStar 1/10th scale 60amp car ESC is the latest addition to Hobby Kings Car ESC range.
Using a Fast Silicon Labs MCU and high quality On-Semiconductor MOSFETs the TrackStar 60A ESC sets a new standard in high quality yet affordable car ESCs. With Intelligent MCU logic the TrackStar series ESCs allow extremely precise start up control and positioning feed back from the motor. This tr
|
|
|
|
|
To suit Turnigy Multistar series ESCs only.
Allows users to change the following parameters:
Battery Chemistry: Lipoly, Nimh, Life
LVC voltage (per cell): Lipo 2.8 - 3.2, Nimh 0.6-0.9, Life 2.2-2.8
LVC Cut off type: Hard cut or Power reduction
Brake: Off, medium and Hard
Timing: Low, Medium, High and Auto
Soft start: Slow, Medium and Fast
Specification:
PCB Size: 48mm x 30mm
Weight: 8g
|
|
|
|
|
Ultra fast microprocessor controlled and extremely low resistance circuit and chip design, water-proof PCB, and aluminum water-cool heatsink for better thermal dissipation are just some of the features in the new TURNIGY Aquastar range of brushless boat speed controllers.
The AquaStar brushless esc is a high performance ESC capable of standard and competition use.
Full protection, include signal l
|
|
|
|