KK Plus V5.5e Multicopter controller

The price includes:

1 x Fully assembled and soldered board with 3 Piezo Gryo ready to use
(All Pre-loaded with Bootloader for easy firmware upgrade)

4 x Male to Male RX cable (while stock last)

Recommended option purchase: MKUSB or the USB Serial linker for easy firmware upgarde.
(Why Bootloader: with bootloader and the KK Plus Flashtool, changing of firmware (Hex File)
is much safer as you are not doing direct programming. This will prevent the wrong setting of
flashing that could turn your KK board to a brick!). Please note the 5.5e are w/o the switch,
ignore the message of switch from the video demo and from the flashtool.
Specification:
Board Dimension: 60mm x 60mm
Mounting hole distance: 45mm

Features:

Support standard KK firmware (With Atmel 168 MCU)
Full 6 motor connection with or without LCD module plug in (with XXControl 1.5d/e firmware)
Low voltage alarm (LVA) support, new 5.5e with integrated LED driver to driver upto 400mA 12V LED Strip
(you can download the sample C source that you can add on to your own code)
Today the code from Mike Barton (XXControler) and David (NextCopter) already supported with LVA
Intergrated Power Distribution board, now you can have better cable management (Typical 30A)
Ready port for optional 5V supply using 7805/Recom for Opto ESC
Support LCD Module for tuning and setup (Great work from Mike to enable PC-less and pot-less tuning)
Enhanced with upgrade ports for DIY upgrade option:
- MEMs Module (MEMS Gyro, Acc)
- Future module (TBA)
- Variable Pot for easy tuning of VRef so you can use the Gyro of your choice or use the MEMS Module
- Ready with 3V supply to support your DIY add-on sensor
Bootloader for easy firmware flash (You can download it from the download page now!)
Video demo on how to flash the firmware is here with the MKUSB or any serial adaptor)

Preloaded with Quad + XXControl V1.5 (need to work with LCD Module to display the setup options).
Optional to flash the firmware of your choice with a small fee: please choose from the option menu.
Credits to Rolf R Bakke, Mike Barton, MinSoo and many others that contribute to the KK firmware
(Firmware is from the 3rd party developer, we cannot guarantee its performance, please test
it with care and refer to forum if you need further information)

Notes:

The default firmware (XXControl) needs LCD module to display the configuration/setup as it disable the pots.
If you dont have the LCD module or you are not planning to get one, please choose the
followings if you dont have USB Serial adaptor or AVR Programmer:

1. XXControl_KR

2. KK firmware

3. Use the Virtual LCD by BlackCat from RCG (you need the Serial Connection)

To Compte a flyable MultiRotor, you need other components like frame, ESC, motor, props and basic
electronics skill to setup a full ready to fly model.